CLTS
Clear Task-Switched Flag in CR0
stableVMJITAOTinstruction
Encodings
| Opcode | Instruction | Op/En | 64-bit | Compat/Legacy | Description |
|---|---|---|---|---|---|
0F 06 | CLTS | ZO | Valid | Valid | Clears TS flag in CR0. |
Measured cost
Loading measurements from arch-data...
Description
Clears the task-switched (TS) flag in the CR0 register. This instruction is intended for use in operating-system procedures. It is a privileged instruction that can only be executed at a CPL of 0. It is allowed to be executed in realaddress mode to allow initialization for protected mode.
The processor sets the TS flag every time a task switch occurs. The flag is used to synchronize the saving of FPU context in multitasking applications. See the description of the TS flag in the section titled "Control Registers" in Chapter 2 of the Intel(R) 64 and IA-32 Architectures Software Developer's Manual, Volume 3A, for more information about this flag.
CLTS operation is the same in non-64-bit modes and 64-bit mode.
See Chapter 27, "Virtual Machine Control Structures," of the Intel(R) 64 and IA-32 Architectures Software Developer's Manual, Volume 3C, for more information about the behavior of this instruction in VMX non-root operation.
Operation
CR0.TS[bit 3] := 0;Flags affected
The TS flag in CR0 register is cleared.
Exceptions
Protected mode
#GP(0) | If the current privilege level is not 0. |
#UD | If the LOCK prefix is used. |
Real address mode
#UD | If the LOCK prefix is used. |
Virtual-8086 mode
#GP(0) | CLTS is not recognized in virtual-8086 mode. |
#UD | If the LOCK prefix is used. |
Compatibility mode
| Same exceptions as in protected mode. |
64-bit mode
#GP(0) | If the CPL is greater than 0. |
#UD | If the LOCK prefix is used. |